Pixel Stuck in Fastboot Mode? How to Fix It Step by Step
If your Pixel is stuck in fastboot mode, it shows the Fastboot Mode screen with a small menu instead of starting Android. Often the fix is simply to select Start with the volume keys and press Power. If the phone keeps coming back to this screen, work through the fixes below in order: the first ones keep your data, and the last ones erase it.
What Fastboot Mode Is on a Pixel
Fastboot mode is the Pixel’s bootloader screen. It runs before Android starts. Google uses it for manual factory resets, and it is also where you open Recovery mode and Rescue mode. You move through the menu with the Volume keys and choose an option with the Power button.
A Pixel usually ends up on this screen for one of two reasons:
- A button combination opened it. On Pixel 6 and later, holding Volume Down + Power while the phone is off opens Fastboot mode. A Volume Down button that is stuck, or pressed by a tight case, can send the phone here every time it starts.
- The bootloader could not start Android. After a failed update, a bad flash or corrupted software, the phone stops here by itself. Some Pixels show a short reason line, such as “boot failure”. Take a photo of the screen before you try anything, because it helps if you need support later.
The Fastboot Mode menu options
| Option | What it does | Erases data? |
|---|---|---|
| Start | Tries to boot Android normally | No |
| Restart bootloader | Reloads the Fastboot Mode screen. It does not repair Android. | No |
| Recovery mode | Opens Android Recovery (reboot, apply an update from ADB, factory reset) | Only if you choose the factory reset option |
| Rescue mode | Waits for Google’s Pixel Update and Software Repair tool on a computer | Only if you choose a factory reset in the tool |
Quick Checks
- Check the Volume Down button. Remove the case and press the button a few times. If it feels stuck or does not click, that alone can explain the problem.
- Unplug accessories. Disconnect USB accessories and anything that covers the buttons.
- Charge the phone. Google recommends a Google 30 W adapter, another 30 W or higher PPS adapter, or a 15 W or higher USB PD adapter. A fully drained Pixel can show no response for up to 25 minutes on the charger.
- Think about what happened first. A system update, a flash, rooting, a drop or water contact each point to a different fix below.
Fixes, From Least to Most Invasive
1. Select Start
- Press Volume Up or Volume Down until Start is shown.
- Press Power once.
- Wait a few minutes for Android to load.
If the phone starts, back up your photos and files straight away. If it returns to Fastboot mode, do not keep repeating this step. Move on.
2. Restart the phone with the Power button
Google’s advice for a Pixel that does not respond is to hold Power for about 35 seconds and then wait about two minutes. Do not hold Volume Down at the same time, because that opens Fastboot mode again.
3. Send a reboot command from a computer
If the buttons do not help, you can tell the bootloader to start Android from a Windows, macOS or Linux computer.
- Download Google’s SDK Platform-Tools, which include fastboot and adb, and extract the ZIP.
- On Windows, install the Google USB Driver first (see our Android USB driver guide for Windows 11). macOS and Linux do not need a driver.
- Connect the phone with a USB data cable and open a terminal in the platform-tools folder.
- Run this command. It lists phones connected in fastboot mode. You should see a serial number.
fastboot devices - Run this command. It asks the bootloader to restart into Android. It does not change or erase anything.
fastboot reboot
Do not try unlock, erase or flash commands: fastboot flashing unlock, for example, wipes all data. Our fastboot commands list explains which commands are safe.
4. Open Recovery mode
- On the Fastboot Mode screen, use the volume keys to show Recovery mode and press Power.
- At the No command screen, hold Power, press Volume Up once, then release both.
- In the Android Recovery menu, choose Reboot system now.
If the phone still returns to Fastboot mode, the next two fixes can reinstall the software without wiping it.
5. Repair the software with Google’s Pixel Update and Software Repair tool
Google’s tool at pixelrepair.withgoogle.com supports the Pixel 4a and later, including Pixel Fold. Google says it can update the phone to the latest software without a factory reset. It works with a locked bootloader, but it only installs the latest update. It cannot install an older version.
- On a computer, open the site in Chrome or Microsoft Edge. Windows users need the Google USB Driver.
- On the phone, open Fastboot mode, select Rescue mode and press Power.
- Connect the phone with a USB cable and follow the steps on the site.
- Choose the update option. Only choose a factory reset if you accept losing your data.
6. Sideload the full OTA update (keeps your data)
Google’s Full OTA Images page says these packages restore a Pixel’s original firmware “without the need to wipe the device or unlock the bootloader”. Back up anyway if you can.
- On the computer, download the full OTA for your exact model. Pick the newest build. Recovery rejects a package made for another model or one older than the build already on the phone.
- On the phone, open Recovery mode as in fix 4 and select Apply update from ADB.
- Connect the USB cable and run
adb devicesto check that the computer sees the phone. - Run the command below, using your file’s real name. It sends the update package to the phone, which checks and installs it.
adb sideload ota-file-name.zip - When it finishes, select Reboot system now. If the transfer fails, try again with another cable or USB port.
7. Factory reset from Recovery mode (erases all data)
Warning: This deletes all apps, photos and files on the phone. After the reset, you must sign in with the Google Account that was on the phone, so make sure you know its email and password.
- Open Recovery mode as in fix 4.
- Select Wipe data/factory reset, then Factory data reset.
- When the screen shows “Data wipe complete”, select Reboot system now.
8. Reflash the factory image if you unlocked the bootloader (erases all data)
If the problem started after rooting, a custom ROM or a manual flash, flash the official factory image. Google’s Android Flash Tool can flash a Pixel that is already in Fastboot mode, but it needs an unlocked bootloader (OEM unlocking must have been turned on earlier) and it erases the phone. Our guide to flashing Pixel factory images covers the basics. Google recommends locking the bootloader again afterwards.
Check Google’s anti-rollback warnings first: after the May 2026 update, the Pixel 10, 10 Pro, 10 Pro XL and 10 Pro Fold cannot boot older Android 16 builds, and after the May 2025 update the Pixel 6, 6 Pro, 6a, 8, 8 Pro and 8a cannot boot older Android 15 builds.
When It Is Hardware or Needs Google Support
Contact Pixel Customer Support or an authorised repair centre if:
- The phone still lands in Fastboot mode after a factory reset or a clean factory image. That points to a hardware fault, such as storage or the main board.
- The buttons do not respond, the screen is damaged, or the phone has been in water.
- The problem began after an official update. In June 2026, Google asked owners whose Pixels froze or looped after the March, April or May 2026 updates to contact support, because the right fix depends on each phone’s state. The July 2026 update (build CP2A.260705.006) included a fix for this for the Pixel 6 to Pixel 10a.
For general boot-loop causes on any Android brand, see our universal boot loop guide.
Related Guides
- Fastboot Commands List Explained (With Examples)
- Phone Stuck in a Boot Loop? Universal Fixes for Android Phones
- Android USB Driver for Windows 11 (All Major Brands)
- Restore Google Pixel XL to Stock / Flash Factory Images
FAQ
Does fastboot mode mean my Pixel is bricked?
No. The Fastboot Mode screen means the bootloader is working. In many cases, selecting Start or restarting fixes it. Even when Android will not load, Google’s repair tool or a full OTA sideload can often reinstall the software.
Will selecting Start or Restart bootloader erase my data?
No. Start, Restart bootloader, fastboot reboot and opening Recovery mode do not delete anything. Data is only erased by a factory reset, by unlocking the bootloader, or by flashing a full factory image.
Can I fix a Pixel stuck in fastboot mode without a computer?
Partly. Selecting Start, a Power-button restart, Recovery mode and a factory reset all work on the phone alone. The Pixel Update and Software Repair tool, a full OTA sideload and fastboot commands need a computer and a USB cable.
Why does my Pixel open fastboot mode every time I restart it?
Either the Volume Down button is held down (stuck, or pressed by a case), or Android cannot load and the bootloader stops there. If the button is fine, try fixes 5 and 6 to reinstall the software.
https://droid-developers.com/pixel-stuck-in-fastboot-mode/https://droid-developers.com/wp-content/uploads/2026/11/pixel-stuck-in-fastboot-mode-featured-1024x538.jpghttps://droid-developers.com/wp-content/uploads/2026/11/pixel-stuck-in-fastboot-mode-featured-150x150.jpgAndroidHelp & TroubleshootingSoftware FixIf your Pixel is stuck in fastboot mode, it shows the Fastboot Mode screen with a small menu instead of starting Android. Often the fix is simply to select Start with the volume keys and press Power. If the phone keeps coming back to this screen, work through the...Fahim MahmudFahim Mahmud[email protected]AdministratorDroid-Developers
Leave a Reply